or the Ins
or the Ins
Installing the appliance
The appliance and the interior fitting are protected for
Remove all packaging and any adhesive tape.
Any remnants of adhesive can be removed using
After transportation the appliance must not be
switched on for 2 hours. This is to allow the refriger-
ant to settle.
Clean the accessories and the inside of the appliance
with warm water and bicarbonate of soda (5 ml to 0.5
litres of water). Rinse and dry thoroughly.
Do not use detergents, abrasive powders, highly per-
fumed cleaning products, wax polishes or cleaning
products containing bleach or alcohol.
The appliance should be positioned in a well ventilated,
Energy use is affected by the ambient temperature.
The appliance should therefore:
not be installed next to radiators, cookers or other
sources of heat
only be installed at a location where the ambient tem-
perature corresponds to the climate classification,
for which the appliance is designed.
The climate classification can be found on the rating plate.
The following table shows which ambient temperature is
correct for each climate classification:
+10 to +32 °C
+16 to +32 °C
+18 to +38 °C
The appliance must have adequate ventilation to ensure
Diagram shows the ventilation requirements when
Under a worktop, or cupboard.
* The clearance space of 10 cm above the appli-
ance may be reduced to 5 cm providing a clear-
ance space 2,5 cm is left on either side of the
Gross capacity (l)
Net capacity (l)
Energy consumption (kWh/day)
Energy class, according to EU Standards
Rated current (A)
Rated power (W)
ZRG 717 CW
Fresh food com.: 155
Fresh food com.: 152