Location, Electrical Connection

Climate
class
Ambient temperature
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Location
The appliance should be installed well away from sources
of heat such as radiators, boilers, direct sunlight etc. En-
sure that air can circulate freely around the back of the
cabinet. To ensure best performance, if the appliance is
positioned below an overhanging wall unit, the minimum
distance between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the appliance
should not be positioned below overhanging wall units.
Accurate levelling is ensured by one or more adjustable
feet at the base of the cabinet.
Warning!  It must be possible to disconnect the
appliance from the mains power supply; the plug
must therefore be easily accessible after installation.
A
B
min.100 mm
20 mm
Electrical Connection
Caution!  Any electrical work required to install this
appliance should be carried out by a qualified
electrician or competent person.
Warning!  This appliance must be earthed.
The manufacturer declines any liability should these
safety measures not be observed.
1
2
3
4
5
Important!  The wires in the mains lead are coloured in
accordance with the following code:
1
Green and Yellow:
Earth
3
Brown:
Live
5
Blue:
Neutral
As the colours of the wires in the mains lead of this ap-
pliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
1. Connect the wire coloured green and yellow to the
terminal marked either with the letter “E“ or by the
earth symbol   or coloured green and yellow.
2. Connect the wire coloured blue to the terminal either
marked with the letter “N“ or coloured black.
3. Connect the wire coloured brown to the terminal ei-
ther marked with the “L“ or coloured red.
4. Check that no cut, or stray strands of wire is present
and the cord clamp 
4
 is secure over the outer
sheath.
5. Make sure the electricity supply voltage is the same
as that indicated on the appliance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug fitted 
2
 .
In the event of having to change the fuse in the plug sup-
plied, a 13 amp ASTA approved (BS 1362) fuse must be
used.
10