Using the Appliance

7
7. Shopping symbol
Visible, when the appliance runs in shopping cooling
mode. See also the chapter on using the refrigerator.
Display background colour
By default the display background is blue.
When a button or knob is used the background turns bright
blue and remains so for a while.
The display background turns red, if the temperature inside
the freezer is too warm (alarm). If this is the case, the digits
show blinking the warmest temperature inside the freezer,
the high temperature symbol flashes and an acoustic alarm
signal is will sound.
The temperature might be too warm in the following cases:
Immediately after switching on
The freezer door was left open for a longer time
There is a fault with the freezer
To switch the alarm sound off press the "E" button. The
display returns to showing the ambient temperature,
however the background remains red until the freezer cools
down properly.
If you do not press any buttons during the alarm, press the
"E" button when the sound finishes to see the warmest
temperature reached during the alarm.
Using the Appliance
Putting it into use 
Place the accessories into the appliance then plug into the
mains socket.
Press the "A" button. The backlight of the display turns on.
The appliance is ready to use.
By pressing the "A" button again the appliance will turn off,
but still under voltage.
Controlling the temperature, setting
The thermostats interrupt the cooling automatically for more
or less time depending on the setting then restarts it
assuring the required temperature.
The temperature of the refrigerator and freezer can be set
by turning knobs "F" and "B", respectively. The selected
temperature is seen blinking on the display.
For everyday use medium setting, i.e. +5°C in the
refrigerator and colder than -18°C is the freezer is
recommended.
Allow the appliance to run for a period of 24 hours
whenever the temperature setting is changed. This will
allow the temperature to stabilise inside the appliance.
The temperature in the refrigerator is affected by not only
the position of the thermostat but the ambient temperature,
frequency of door openings and the quantity of food put into
it etc.
When the coldest temperature possible is set - in
case of increased demand e.g. during heatwaves
- the compressor may operate continually. This does
not cause damages to the appliance.
How to use the refrigerator
Sufficient air circulation is required for the proper
operation of this appliance. For this reason you are
asked not to cover the air circulation gaps behind the
shelves (e.g. with tray etc.).
Do not put hot food into the refrigerator. Allow
it to reach room temperature naturally. In this
way unnecessary frost building up can be avoided.
Food odours can be transferable, so it is
essential to put foods in closed dishes or wrap
them in cellophane, aluminium foil, grease-proof
paper or cling film before placing them into the
refrigerator. This way foods will keep their moisture
e.g. vegetables will not dry out after some days.