An inlet hose is supplied and can been found
inside the machine drum.
Do not use the hose from your previous
machine to connect to the water supply.
1. Open the porthole and extract the inlet
2. Connect the hose with the angled
connection to the machine.
Do not place the inlet hose downwards.
Angle the hose to the left or right depending
on the position of your water tap.
3. Set the hose
correctly by loosening
the ring nut.
After positioning the
inlet hose, be sure to
tighten the ring nut
again to prevent leaks.
4. Connect the hose to a tap with a 3/4” thread.
Always use the hose supplied with the
appliance. The inlet hose must not be
lengthened. If it is too short and you do not
wish to move the tap, you will have to
purchase a new, longer hose specially
designed for this type of use.
comply with local
water authority and
The appliance must be connected to a cold
A minimum water pressure of 0.05 MPa (0.5
bar) is required for safe operation of the
If you cannot make the cold water connection
direct from the rising mains, you may be able
to operate the appliance from your cold water
There should be a minimum distance of 5.02m
(16.5 ft) between the appliance’s inlet and the
bottom of the water storage tank.
This appliance is designed to be permanently
plumbed into your home's drainage system
using one of the following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain
hose using the «U» piece supplied. Place the
drain hose into your standpipe, which should
have an internal diameter of approximately
38mm thus ensuring there is an air break
between the drain hose and standpipe.
When discharging into a standpipe ensure that
the top of the standpipe is no more than 90
cm (35.4'') and no less than 60 cm (23.6'')
above floor level.
30 cm (12")
38 mm (11.2)
Sport Shoes 40°
Easy Iron 40°
Smart 132973870 amended.qxd 03/04/2007 11.10 Pagina 29