Technical specifications, Installation

10
ZI 9155 A
ZI 9225 A
POWER SUPPLY VOLTAGE AND FREQUENCY
220-240 V / 50 Hz
220-240 V / 50 Hz
TOTAL POWER ABSORBED
110
W
140 W
AVERAGE DAILY UNITS ELECTRICITY (*)
0,41
kWh
0,44
kWh
GROSS CAPACITY
158 l
230 l
NET CAPACITY
154 l
228 l
(*)  This figure is based on standard test results in accordance with European Standard EN153. Actual
consumption will depend on how the appliance is used and where it is located.
Technical specifications
Warning
IF  YOU ARE  DISCARDING AN  OLD
APPLIANCE THAT HAS A LOCK OR CATCH
ON THE DOOR, YOU MUST ENSURE THAT
IT IS MADE UNUSABLE TO PREVENT
YOUNG CHILDREN BEING TRAPPED
INSIDE.
Depending upon the position which you choose for
your appliance, you may wish to reverse the way in
which the door opens. To do this, refer to instructions
under “Door reversal”.
Positioning
The appliance should only be installed at a location
where the ambient temperature corresponds to the
climate classification indicated on the rating plate,
which is located on the inside left of the appliance.
The following table shows which ambient
temperature is correct for each climate classification.
SN
+10°C   to   +32°C
ST
+18°C   to   +38°C
Installation
The appliance should be located in a dry
atmosphere, out of direct sunlight and away from
continuous heat and extreme temperature, e.g. not
next to a boiler or radiator or in a very cold room e.g.
an outhouse. If these temperatures are exceeded i.e.
warmer or colder, then the appliance may not
operate correctly.
For building-in and door reversal instructions please
refer to the relevant instructions on the following
pages.
Important
It must be possible to disconnect the appliance
from the mains power supply; the plug must
therefore be easily accessible after installation.