THE ELECTRICAL CONNECTIONS
WARNING: THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this safety
measure not be observed.
If the plug that is ﬁtted to your appliance is not
suitable for your socket outlet, it must be cut off and
the appropriate plug ﬁtted.
Remove the fuse from the cut off plug.
The cut off plug should then be disposed of to
prevent the hazard of shocks in case it should be
plugged into a 13amp socket in another part of your
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow
If you ﬁt your own plug, the colours of the wires in
the mains lead of your appliance may not
correspond with the markings identifying the
terminals in your plug, proceed as follows:
Connect the Green and Yellow (earth) wire to the
terminal in the plug which is marked with the letter
«E» or the earth symbol
, or coloured green and
Connect the blue (neutral) wire to the terminal in
the plug which is marked with the letter «N» or
Connect the brown (live) wire to the terminal in the
plug which is marked with the letter «L» or
The plug moulded onto the lead incorporates a fuse.
For replacement, use a 13amp BSI362 fuse. Only
ASTA or BSI approved fuses should be used.
The plug must not be used if the fuse cover/carrier
is lost. The cover/carrier is indicated by the
coloured insert at the base of the plug.
GREEN & YELLOW
13 AMP. FUSE
A replacement cover/carrier must be obtained from
your local Zanussi Service Force Centre whose
address is listed in the Customer Care Booklet
which accompanies your instruction manual.
This appliance complies with the E.E.C. Directive No. 87/308
of 2.6.87 relative to radio interference suppression.
This appliance complies with the following
of 19.2.73 (Low Voltage Directive) and
of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
Please ensure that when the appliance is installed it is
easily accessible for the engineer in the event of a