Changing the remote control ID of the remote control
Perform each of the following steps within 1 minute. Otherwise, the setting will be
Press CODE SET on the remote control using a pointed object such as the tip of a
Use the numeric keys to enter “5019” (ID1) or “5020” (ID2).
Once the remote control ID is registered successfully, SOURCE/RECEIVER blinks twice.
If it blinks 6 times, registration failed. Repeat from step 1.
• The registered remote control codes (p.104) are not cleared even if you change the remote control ID.
Changing the frequency step setting (TU)
(Asia and General models only)
Change the frequency step setting of this unit depending on your listening environment.
Switching the video signal type (TV FORMAT)
Switch the video signal type of this unit so that it matches to the format of your TV.
Korea and General models: NTSC
Other models: PAL
Removing the limitation on HDMI video output
This unit automatically detects resolutions supported by a TV connected to the HDMI
If you want to select a resolution in “Resolution” (p.93) regardless of the detection
results or if this unit does not detect it correctly, disable the monitor check function.
• In case this unit becomes inoperable because videos from this unit cannot be displayed on the TV after
“MON.CHK” is set to “SKIP”, reset the setting to “YES.
Restoring the default settings (INIT)
Restores the default settings for the selected item.
Select this when you want to adjust the FM frequency by 100-kHz steps and
AM by 10-kHz steps.
Select this when you want to adjust the FM frequency by 50-kHz steps and
AM by 9-kHz steps.
TV FORMAT- PAL
Enables the monitor check function. (Outputs video signals with a
resolution supported by the TV only.)
Disables the monitor check function. (Outputs video signals with a
specified resolution regardless of compatibility with the TV.)
Restores the default settings for video configurations.
Restores the default settings for this unit.
Does not perform an initialization.
MON.CHK - YES