Yamaha RX-V2067_IM Owner Manual

SETUP

SETUP
Setting various functions (Setup menu)
 En
 99
Setting this unit’s video output function 
Video setup items
Analog-to-analog video conversion
Analog to Analog Conversion
Enables or disables video conversion between analog video jacks.
Adjusting video with conversion of video 
signal to HDMI
Processing
Adjust video with conversion of video input to HDMI video.
Resolution
J
1
Analog to Analog 
Conversion
Enable or disable video conversion between analog 
video jacks.
Processing
Enable or disable adjustment of resolution, aspect 
ratio and video signal correction for video signal 
converted to HDMI video.
Off
Disables video conversion between analog video 
jacks.
On (Default)
Enables video conversion between analog video jacks.
Analog-to-HDMI video conversion is always possible unless 
video signals are being input at the HDMI input jacks or 1080p-
resolution analog video signals are being input (
☞p. 141
).
This unit does not convert 480 line video signals and 576 line 
video signals interchangeably.
480p-, 576p-, 1080i- and 720p-resolution video signals can not 
be output at the S-video and video jacks of MON.OUT/ZONE 
OUT (
☞p. 141
).
The converted video signals are only output at the MONITOR 
OUT jacks.
When composite video or S-video signals from a VCR are 
converted into component video signals, the picture quality may 
suffer depending on your VCR.
Unconventional signals input at the composite video or S-video 
jacks cannot be converted or may be output abnormally. In such 
cases, set “Analog to Analog Conversion” to “Off.”
Off (Default)
Video are not adjusted with processing.
On
Video are adjusted with processing.
Auto (Default)
Automatic upscaling in accordance with TV 
resolution.
480p (576p)
Upscaling to 480p (576p).
720p
Upscaling to 720p.
1080i
Upscaling to 1080i.
1080p
Upscaling to 1080p.
Through 
No upscaling.
When a TV is connected to this unit via the HDMI jack, this unit 
automatically detects a resolution that the TV supports. Only the 
detected resolution can be selected.
If this unit cannot detect the resolution that the TV supports, set 
“MONITOR CHECK” in the Advanced Setup menu to “SKIP” 
(
☞p. 123
) and try again.
J
1 :
This item can be set, when “Processing” is set to “On.”