SETUP

SETUP
 En
 121
The Advanced Setup menu can be used for unit initialization and other useful extended functions. The Advanced Setup menu can be operated as follows.
Displaying/Setting the Advanced Setup 
menu
1
Switch this unit to the standby mode.
2
Press MAIN ZONE 
A
 while pressing and holding 
STRAIGHT on the front panel.
Release STRAIGHT when “ADVANCED SETUP” is displayed 
on the front panel display. 
After a few seconds, the top menu items are displayed.
3
Press PROGRAM 
l
 / 
h
 repeatedly to select the item 
to be set from the following items.
In the Advanced Setup menu, you can set the following settings.
4
Press STRAIGHT repeatedly to select the value you 
want to change.
5
Switch this unit to the standby mode, and then 
switch it on again.
The settings become effective and the unit is powered on.
Setting the impedance of speakers 
Changes the unit settings depending on the impedance of the 
speakers connected.
J
2
Remote sensor
Activate or deactivate the signal-receiving capability of the remote 
control sensor on the front panel of this unit.
Extended functionality that can be configured as needed (Advanced Setup menu)
PROGRAM 
l
 / 
h
MAIN ZONE 
A
STRAIGHT
SPEAKER IMP.
Sets the impedance of speakers.
REMOTE SENSOR
Activate or deactivate the signal-receiving capability 
of the remote control sensor.
REMOTE CON AMP
Changes the remote control ID of a receiver.
TUNER FRQ 
STEP
J
1
Selects one of the following FM/AM frequency steps.
TV FORMAT
Specifies the TV’s color encoding format.
MONITOR CHECK
Removes the up-scaling limitation on HDMI video 
output.
RECOV./BACKUP
Save and restore the settings of this unit.
INITIALIZE
Initializes various settings for this unit.
FIRM UPDATE
Update the firmware of this unit.
VERSION
Check the version of firmware currently installed on 
this unit.
Select the impedance when 6
Ω speakers are 
connected.
 (Default)
Select the impedance when speakers above 8
Ω are 
connected.
ON (Default)
Activate the signal-receiving capability of the remote 
control sensor
OFF
Deactivate the signal-receiving capability of the 
remote control sensor
“ON” is recommended in most cases.
S P E A K E R I M P .
8 M I N
6 MIN
8 MIN
R E M O T E S E N S O R
O N
J
1 :
Asia and General models only.
J
2 :
For detailed procedures of speaker impedance settings, refer to “Changing 
speaker impedance” (
☞p. 21
).