I Connecting the AM loop antenna
Set up the AM loop antenna, then connect it.
Press and hold the tab to insert the AM loop
antenna lead wires into the AM ANT and
Orient the AM loop antenna for the beat
• The AM loop antenna can be removed from the stand and
attached to a wall, etc.
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
A properly installed outdoor antenna provides clearer
reception than an indoor one. If you experience poor
reception quality, an outdoor antenna may improve the
quality. Consult the nearest authorized YAMAHA
dealer or service center about the outdoor antennas.
Connecting the Antennas
Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal
Connect each antenna correctly to the designated terminals.
I Connecting the indoor FM
Connect the included indoor FM antenna to the 75
UNBAL. FM ANT terminal.
D-TV / LD
FREQUENCY STEP switch (China and General
Because the interstation frequency spacing
differs in different areas, set the
FREQUENCY STEP switch (locating on
the rear panel) according to the frequency
spacing in your area.
North, Central and South America:
100 kHz/10 kHz
Other area: 50 kHz/9 kHz
Before setting this switch, disconnect the
AC power plug of this unit from the AC
Ground (GND terminal)
For maximum safety and minimum
interference, connect the antenna GND
terminal to a good earth ground. A good
earth ground is a metal stake driven into
AM loop antenna
01.7.6, 9:27 AM