7

5. Attach the Fan Cover Bracket to unit with the 4 

screws removed in step 1 above. See Figure 16. 

The Hood Fan Unit is now rotated for vertical 

exhaust operation.

Wire box

Figure 16

6. Attach the Exhaust Damper Assembly to the fan 

cover on the top of the outercase cabinet by sliding 

it into the slits in the same direction as the arrow. 

Use 1 Tapping Screw 4 X12 mm from the INSTAL-

LATION HARDWARE and tighten into place. See 

Figure 17.

Exhaust damper assembly

Figure 17

9. OVEN INSTALLATION

THIS OVEN CANNOT BE PROPERLY INSTALLED 

WITHOUT REFERRING TO THE MOUNTING IN-

STRUCTIONS FOUND ON BOTH TEMPLATES.
READ AND FOLLOW MOUNTING INFORMATION ON 

BOTH TOP CABINET AND WALL TEMPLATES.

MOUNTING PLATE

1. Separate 4 Toggle Bolts 2, packed in the INSTALLA-

TION HARDWARE, from the Toggle Nuts.

2. Use Wood Screws 1 to attach Mounting Plate to the 

stud or studs. Use Toggle Bolts to attach Mounting 

Plate through the holes at A, B, C and D; UNLESS 

THOSE HOLES ARE LOCATED ON THE STUD. 

Insert one Toggle Bolt into A, B, C and D where ap-

propriate (these correspond to the holes of the Wall 

Template) and put the Toggle Nuts onto the Toggle 

Bolts. Figure 18.

  Refer to instructions in Wall Template.

Mounting

plate

Figure 18

3. Position the Mounting Plate with the Toggle Bolts 

attached at the wall location and insert Toggle Nuts 

and Bolts through the holes in the wall with the Toggle 

Nuts closed. Figure 19. Use Wood Screws 1 to attach 

the Mounting Plate to studs.

Space more than

wall thickness

Wall

Figure 19

 Note: Before insertion, be sure you leave a space 

more than the thickness of the wall between the 

Mounting Plate and the end of each of the Toggle Nuts 

(in the closed position). If you do not leave enough 

space, the Toggle Nut will not be able to open on the 

other side of the wall. Also, once a Toggle Nut opens, 

it cannot be withdrawn from the hole; therefore make 

sure all of the Toggles are in the correct position before 

insertion.

4. Align the Mounting Plate carefully and hold in position 

while tightening Toggle Bolts. Pull Toggle Bolt toward 

you and turn clockwise to tighten. Figure 20.

Figure 20