14 

Do not use or leave the hood without the 

lamp correctly mounted due to the 
possible risk of electric shocks. 

Never use the hood without effectively 
mounted grids. 

The hood must NEVER be used as a 
support surface unless specifically 

indicated. 
Use only the fixing screws supplied with 

the product for installation or, if not 
supplied, purchase the correct screws 

type. 
Use the correct length for the screws 

which are identified in the Installation 
Guide. 

In case of doubt, consult an authorised 
service assistance centre or similar 

qualified person.  
WARNING! Failure to install the screws 

or fixing device in accordance with these 
instructions may result in electrical 

hazards. 
We will not accept any responsibility for 

any faults, damage or fires caused to the 
appliance as a result of the non-

observance of the instructions included in 
this manual. 

This appliance is marked according to the European directive 
2012/19/EC on Waste Electrical and Electronic Equipment 
(WEEE). By ensuring this product is disposed of correctly, you 
will help prevent potential negative consequences for the 
environment and human health, which could otherwise be 

caused by inappropriate waste handling of this product. 

The symbol 

 on the product, or on the documents 

accompanying the product, indicates that this appliance may 
not be treated as household waste. Instead it should be taken 
to the appropriate collection point for the recycling of electrical 
and electronic equipment. Disposal must be carried out in 
accordance with local environmental regulations for waste 
disposal. 
For further detailed information regarding the process, 

collection and recycling of this product, please contact the 
appropriate department of your local authorities or the local 
department for household waste or the shop where you 
purchased this product. 
 
Appliance designed, tested and manufactured according to: 
• Safety: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC 
62233. 
• Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO 
5168; EN/IEC 60704-1; EN/IEC 60704-2-13; EN/IEC 60704-3; 
ISO 3741; EN 50564; IEC 62301. 
• EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2; 
EN/IEC 61000-3-2; EN/IEC 61000-3-3. Suggestions for a 
correct use in order to reduce the environmental impact:  
Switch ON the hood at minimum speed when you start 

cooking and kept it running for few minutes after cooking is 
finished. Increase the speed only in case of large amount of 
smoke and vapour and use boost speed(s) only in extreme 
situations. Replace the charcoal filter(s) when necessary to 
maintain a good odour reduction efficiency. Clean the grease 
filter(s) when necessary to maintain a good grease filter 
efficiency. Use the maximum diameter of the ducting system 
indicated in this manual to optimize efficiency and minimize 
noise. 
 
Additional Installation Specifications:  
Use only the fixing screws supplied with the product for 
installation or, if not supplied, purchase the correct screws 
type. 
Use the correct length for the screws which are identified in 

the Installation Guide. 
In case of doubt, consult an authorised service assistance 
centre or similar qualified person.  
 
WARNING!  Failure to install the screws or fixing device in 
accordance with these instructions may result in electrical 
hazards.