CAUTION

Personal Injury Hazard

Tightly-closed utensils
could explode. Closed
containers should be opened
and plastic pouches should be
pierced before cooking.

Utensil Test:

1. Fill a microwave-safe container with 1 cup of cold
    water (250ml) along with the utensil in question.
2. Cook on maximum power for 1 minute.
3. Carefully feel the utensil. If the empty utensil is
    warm, do not use it for  microwave cooking.
4. Do not exceed 1 minute cooking time.

UTENSILS

See the instructions on "Materials you can use in

microwave oven or to be avoided in microwave oven."

There may be certain non-metallic utensils that are not

safe to use for microwaving. If in doubt, you can test the

utensil in question following the procedure below.

1. A short power-supply cord is provided to reduce the risks resulting from becoming entangled in

    or  tripping over a longer cord.

2. Longer cord sets or extension cords are available and may be used if cared  is exercised  in

    their  use.

3. If a long cord sets or extension cord is used:

   1) The marked electrical rating of the cord set or extension marked electrical rating of the cord

        set or extension cord should be at least as great as the  electrical rating of the appliance.

    2) The extension cord must be a grounding-type  3-wire cord; and

    3) The longer cord should be arranged so that it will not drape over the countertop or tabletop

        where it can be pulled on by children or tripped over unintentionally.

Radio Interference

1. Operation of the microwave oven may cause interference to your radio, TV

     or similar equipment.

2. When there is interference, it may be reduced or eliminated by taking the

    following measures:

    1) Clean door and sealing surface of the oven

    2) Reorient the receiving antenna of radio or television.

    3) Relocate the microwave oven with respect to the receiver.

    4) Move the microwave oven away from the receiver.

    5) Plug the microwave oven into a different outlet so that microwave oven

             and receiver are on different branch circuits.