Installation
44
Fixed connection
Fit the power line with an omnipolar circuit
breaker in compliance with installation
regulations.
The circuit breaker should be located near
the appliance and in an easily reachable
position.
Connection with plug and socket
Make sure that the plug and socket are of
the same type.
Avoid using adapters and shunts as these
could cause overheating and a risk of
burns.
Cable replacement
1. Unscrew the rear casing screws and
remove the casing to access the terminal
board.
2. Replace the cable.
3. Make sure that the cables follow the best
route in order to avoid any contact with
the appliance.
5.2 Water connection
Connect the water inlet socket on the back
of the appliance to a water socket with a
threaded ¾” opening.
Power voltage
Danger of electrocution
• Disconnect the main power supply.
Improper use
Risk of damages to the appliance
• If the water pipe is new or has not been
used for a long time, before making the
connection, let the water flow to ensure
that it is clear and free from impurities.
• The inlet pressure should be between
50 kPa min. and 500 kPa max.