Use
13
EN
• OFF mode: from the ON position, press
and hold PT2 until it turns off. Only the
symbol on DSP1 remains illuminated.
First use
When using for the first time, or after a
power failure, the left oven display, DSP1,
will display a flashing
symbol.
Before starting any oven cooking, the
current time must be set.
Setting the current time
Adjusting the current time:
• Turn PT1 to the right or to the left to
increase or decrease the time. (Hold the
knob in one direction to accelerate the
change in time).
• When PT1 is released, after a few
seconds the display will be steadily
illuminated and only the colon
separating hours from minutes will flash,
indicating that it is working properly. (The
display will also show the
symbol).
Selecting an oven function
While the oven is in the ON mode only,
any cooking function can be selected by
simply turning PT2 to the right or left. The
selected function will change color to red
on the display. After the selection, the preset
cooking temperature for that function will be
displayed on DSP3.
Cooking at a preset temperature
After selecting the desired oven function, the
oven will start the cooking procedure at the
preset temperature and the symbol
will
turn on. Prior to cooking, there is a preheat
stage, that allows the oven to rapidly heat
up to the cooking temperature. The
symbol flashes on
DSP3 to
indicate that oven preheating is in progress.
When preheating stops, the
symbol will be steadily illuminated and a
buzzer will sound to indicate that the food
can be placed inside the oven.
Changing the preset temperature
The temperature preset for each function
can be changed to suit the user's needs.
At any time while cooking is in progress,
turn PT1 in either direction to raise or lower
the cooking temperature by
5 degrees at a
time. (PT1 can also be held to the left or
right in order to speed up or slow down the
temperature adjustment).
Note: It might become necessary
to change the current time, for
example when changing over from
daylight savings to standard time.
Starting in the stand-by mode:
• Press and hold PT1 for a few
seconds until the symbol
stops flashing.
• repeat the steps described in
paragraph “Setting the current
time”.