Installation

8

•  Wire size and connections must conform 

to the requirements of the National 
Electrical Code, ANSI/NFPA 70 
ELECTRICAL CODE (*) – latest edition 
or CSA Standard C22.1-94, Canadian 
Electrical code, Part 1 (**) and CSA 
C22.2 No. O-91 or latest edition and 
all local codes and ordinances for the 
kilowatt rating of the appliance. 
IMPORTANT: Observe all governing 
codes and ordinances.

•  Copies of the standards listed above 

may be obtained from:

•  (*) National Fire Protection Association, 

One Batterymarch Park, Quincy, 
Massachusetts 02169-7471

•  (**) CSA International 8501 East 

Pleasant Valley Road Cleveland, Ohio 
44131-5575.

1.3 Electrical connection

This appliance is manufactured with a 
green or green-yellow ground wire 
connected to the oven chassis.

To prepare the connection between the 
oven and the junction box:
•  Disconnect the power supply to the 

junction box.

•  Feed the flexible cable conduit from the 

oven through the opening of the cabinet.

•  Remove the junction box cover, if 

present.

•  Install a UL-listed or CSA-approved 

conduit connector to the junction box.

•  Route the flexible cable conduit from the 

oven to the junction box through a UL-
listed or CSA-approved conduit 
connector.

•  Tighten the screws on the conduit 

connector.

IMPORTANT: Any local codes or 
ordinances should be give priority over 
these instructions.
Frame grounded by connection of 
grounding wire to neutral wire. If used in the 
new branch circuit installation (1996 NEC) 
or if local codes do not permit grounding 
through neutral wire, open the connection 
and use the grounding wire to the ground 
unit in compliance with local codes. 
Connect the neutral wire to the branch 
circuit’s neutral conductor in the usual 
manner:
•  Disconnect the ground from the neutral 

at the free end of the conduit.

•  Use the grounding terminal or lead to 

ground the unit.

•  Connect the neutral terminal or wire to 

the branch circuit neutral in the usual. 
manner.

Warning
Electrical shock hazard

•  Disconnect power to the junction box 

before connecting.

•  Electrically ground the appliance with 

green or green-yellow wire.

FAILURE TO FOLLOW THESE 
INSTRUCTIONS COULD 
RESULT IN DEATH, FIRE OR 
ELECTRICAL SHOCK.