Conversion Kit

7

Conversion Kit

5)

Follow these instructions to leak test the appliance:
Use a brush and liquid detergent to test all gas connections for leaks. Bubbles around connections
indicate a leak. If a leak appears, shut off the gas valve controls and adjust the connections. Then check
the connections again. Remove all the detergent product from the range. Replace the parts on the
burner and turn the knobs on the gas tap pins.

NEVER TEST FOR GAS LEAKS WITH A MATCH OR OTHER FLAMES.

6)

Check that the flame at the maximum flame position has a blue color. It should be clean and soft in
character. No blowing or lifting of flame should occur. Occasional orange flashes are normal and reflect
different elements in the air or gas.

7)

Wipe away all the detergent product from the range.
Replace the parts on the burner and turn the knobs on the gas tap valves.

Minimum adjustment for Natural Gas

Light the burner and turn the knob to the minimum position 

. Remove the gas tap knob and turn the

adjustment screw at the side of the tap rod until the desired minimum flame is achieved.
Refit the knob and verify that the burner flame is stable (when turning the knob rapidly from the
maximum to the minimum position the flame must not go out).
Repeat this operation on the remaining gas taps on the hob.

Minimum adjustment for LP Gas
Turn off the burners and unplug the appliance from the electrical power supply.
For regulating the minimum with LP, the screws at the side of the tap rod must be turned clockwise all the
way. Once the regulation has been completed, replace the seal on the by-passes using paint or similar
materials. Follow the instructions given in point 9 to locate the adjustment screws.

8)

Completely fill out the conversion label (part no. 92849A078) and attach it to the rear of the appliance.
Do not cover any other labels with the conversion label.

9)

For installation of the appliance at high altitude, please consult your local gas company for their
recommendation of the correct orifice sizes and any other necessary adjustments that will provide
proper gas combustion at specified altitudes.

10)

Save the nozzles removed from the unit along with these instructions for possible future use.

NATURAL GAS:
To convert back to Natural Gas: Follow steps 1 through 9 and replace the nozzles in the order in which
they were removed.