Instructions for the Installer

6

3. PREPARING THE BUILT–IN OVEN

  WARNING

EXCESSIVE WEIGHT HAZARD

-  Use two or more people to move and install the oven

-  Failure to do so can result in back or other injury.

The oven is designed for installation into any type of cabinetry as long as it is heat-resistant. Proceed
according to the dimensions shown in Pictures 1, 2 and 3. For installing under a countertop, follow the
dimensions given in Picture 3. For installing under a countertop beneath a cooktop with controls
connected to the oven, ensure a minimum clearance from any side walls of at least 110 mm as shown in
Picture 1. 
For installing in a column, follow the dimensions given in Picture 2 allowing for a clearance of 80 to 90
mm at the top and sides of the column. Tighten the four screws (ref. A) inside the frame to secure (Pic.
1). 
For installing beneath a separate cooktop, allow for a rear and bottom clearance as shown in Picture 1
(ref. B). See instructions regarding fitting and securing the cooktop. 

It is important to follow these instructions before and during the oven installation:

Decide on the final location of the oven. Locate the existing wiring to avoid drilling into or severing
wiring during installation.

To avoid damage to the floor, place the oven on cardboard prior to installation. Do not lift by the door
handle or any part of the frame or trim.

Remove the shipping materials and tape from the oven.

Remove the literature contained in the package.

Remove and set aside racks and other parts from inside the oven.

Move the oven on the cardboard close to the oven’s final location.

Remove the oven door (see paragraph “

9.2 Removing the door” in the Instructions for the User

booklet)

IMPORTANT: Use both hands to remove the oven door.