Important Safety Instruction

5

2. GENERAL INSTALLATION INSTRUCTIONS

Proper installation is your responsibility. Have a qualified technician install this oven. Make sure
you have everything necessary for correct installation. It is the responsibility of the installer to comply
with installation guidelines specified on the model/serial ID plate. The model/serial ID can be found
on the internal frame of the oven when the door is opened.

Have your oven installed and properly grounded by a qualified installer, in accordance with
these installation instructions. Grounding is mandatory according to the provisions of the
electrical system safety regulations. If this appliance is connected to an outside electrical power
source, it must be grounded in compliance with local laws, or, if no local laws exist, in compliance
with the national ANSI / NFPA 70 code of electrical regulations.

Make sure that the voltage and dimensions of the supply line correspond to the information indicated
on the model/serial rating plate. A multi-polar cut-out must be available on the supply line with a
contact opening distance equal to or greater than 3mm, located in an easily accessible position near
the appliance.

Do not attempt to repair or replace any part of your oven unless it is specifically recommended in this
manual. All other service procedures should be performed by a qualified technician.

This oven is not suitable for installation and use in mobile homes or campers.

Electrical grounding is required. See the “Electrical Requirements” section. It is the customer’s
responsibility:

-  To contact a qualified electrical installer,
-  To ensure that the electrical system is adequate and in compliance with the national ANSI /

NFPA 70 ELECTRICAL CODE – latest edition – Or the CANADIAN ELECTRICAL CODE,
C22.11 – 1982 and C22.2 No. 01982 – or latest edition – and all local codes and ordinances.
IMPORTANT: Observe all government codes and ordinances.