en Operating modes
Exhaust air mode
The air must not be discharged into a flue that is
used for exhausting fumes from appliances burning gas
or other fuels (not applicable to appliances that only
discharge the air back into the room).
Before conveying the exhaust air into a non-
functioning smoke or exhaust gas flue, obtain the
consent of the heating engineer responsible.
If the exhaust air is conveyed through the outer wall,
a telescopic wall box should be used.
To bind odours in air recirculation mode, you
must install an activated carbon filter. The different
options for operating the appliance in air recirculation
mode can be found in the brochure. Alternatively, ask
your dealer. The required accessories are available
from specialist retailers, from customer service or from
the Online Shop.
Operating the appliance
Press the buttons briefly to activate the various
functions. The function you are trying to select will
not be activated if you hold the button down for too
The appliance will emit a beep to confirm that a
button has been pressed.
Switch on the extractor hood when you start
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Use the remote control to set and adjust the various
different functions of your appliance.
The remote control requires 23AE 12 V batteries.
For information on how to insert the batteries, refer to
the section entitled~ "Cleaning and maintenance"
on page 8
Heat and penetrating moisture may damage the
remote control. Never expose the remote control to
intense heat or moisture.
Connecting the remote control to the appliance
If the appliance cannot be operated with the remote
control, e.g. after the battery has been changed, the
connection between the remote control and the
appliance must be re-established.
Press and hold the
Attach the appliance to the mains voltage.
A long audible signal sounds. The remote control
has been connected to the appliance.
If no audible signal sounds within 30 seconds,
repeat this procedure.
The air which is drawn in is cleaned
by the grease filters and conveyed to
the exterior by a pipe system.
The air which is drawn in is cleaned by
the grease filters and an activated
carbon filter, and is conveyed back into
Increase fan setting
Decrease fan setting