Control panel model 2, Setting the fan, Intensive setting, Automatic mode, Sensor control, Lighting

en    Operating the appliance

6

Control panel model 2

Setting the fan

Switching on

Touch the 

#

 symbol.

The fan starts at setting 

ƒ

.

Slide your finger across the III settings range to 

change the fan speed.

Switching off
Touch the 

#

 symbol.

Intensive setting

You can use the intensive setting if there is a large 

build-up of odours and fumes/vapours.
Slide your finger to the right across the III settings 

range. Intensive settings 

‚ 2

 and 

ƒ2

 can be selected.

After approximately six minutes, the electronics 

automatically reduce the fan to a lower setting . If you 

want to end the intensive setting before the preset time 

expires, slide your finger to the left across the III 

settings range until the required fan setting is reached.
Boost function
The boost function is a short-term maximum power 

setting which can be activated at any fan setting.
Touch the 

&

 symbol. After approximately 20 seconds, 

the fan switches back to the previously set fan setting.

Automatic mode

Switching on

Touch the 

#

 symbol.

The fan starts at setting 

ƒ

.

Touch the 

!

 symbol.

The optimum fan setting 

ƒ

 or 

 is automatically 

set via a sensor.

Switching off

Touch the 

!

 or 

#

 symbol to switch automatic mode 

off.
The fan switches off automatically if the sensor no 

longer detects a change in the air quality of the room.
Automatic mode can run for a maximum of 4 hours.

Sensor control

In automatic mode, a sensor in the extractor hood 

detects the intensity of the cooking and roasting 

odours. Depending on the sensor setting, the fan 

automatically switches to another fan setting.
Default sensitivity setting: 

Lowest sensitivity setting: 

Highest sensitivity setting: 

If the sensor control responds too quickly or too slowly, 

it can be changed accordingly:

1.

When the fan is switched off, hold the 

!

 symbol 

for approximately four seconds. The setting is 

displayed.

2.

The sensor control setting can be changed by 

sliding your finger to the right or to the left across the 

||| settings range.

3.

To confirm the entry, hold the 

!

 symbol for 

approximately four seconds.

Lighting

The lighting can be switched on and off independently 

of the fan.
Touch the 

=

 symbol.

Setting the brightness
Press and hold the 

=

 symbol until the desired 

brightness is reached.

LQW

DXWR

Explanation

#

Fan on/off

=

Light on/off/dimming

&

Boost function (short-term maximum power)

!

Automatic mode with fan run-on

-|||+ Range of fan settings