Basic Operation

Basic Operation
-29
"On-screen Display (Example)
➝➝
Using Analog
RGB
Using
Component
INPUT 2 Mode
   Using S-Video
INPUT 3 Mode
   Using Video
3
Press 
 or 
 on the re-
mote control to select the IN-
PUT Mode.
After pressing 
 once, use the but-
ton to select the desired INPUT Mode.
Note
When no signal is received, “NO
SIGNAL” will be displayed. When a
signal that the projector is not pre-
set to receive is received, “NOT
REG.” will be displayed.
About the INPUT Modes
INPUT 1 Mode
Using
   DVI digital
4
Press 
 or 
 on the remote
control to adjust the volume of
the speaker.
Note
Pressing 
 will raise the volume.
Pressing 
 will lower the volume.
On the projector, the volume can be
adjusted by pressing 
 or 
.
 , 
 on the projector operate
as cursor buttons (
) when
selecting setup or adjustment
functions while adjusting menus or
the lens.
VOLUME
buttons
Used for projecting im-
ages from equipment that
sends RGB signals or
Component  signals con-
nected to the DVI-DIGI-
TAL/ANALOG input port.
Used for projecting im-
ages  from equipment
connected to the S-
VIDEO input terminal.
Used for projecting im-
ages   from equipment
connected to the VIDEO
input terminal.
INPUT 1
(RGB/
Component)
INPUT 2
(S-Video)
INPUT 3
(Video)