Controlling the Projector via LAN

-17
Controlling the Projector via LAN
After connecting the projector to your network, enter the projector IP address in 
“Address” on Internet Explorer (version 6.0 or later) using a computer on the network to 
start a setup screen that will enable control of the projector via the network.
Controlling the Projector 
Using Internet Explorer 
Complete connections to external 
equipment before starting the operation. 
(See pages 21-25 of the projector's 
operation manual.)
Complete the AC cord connection. (See 
page 25 of the projector's operation 
manual.)
When connecting the projector to the LAN, use 
a commercially available LAN cable (UTP cable, 
Category 5, cross-over type).  When 
connecting the projector to a hub, use a 
straight-through cable.
Note
1
  Start Internet Explorer on the 
computer.
2
  Enter “http://” followed by the 
projector IP address set by the 
procedure on page 
16
 followed by 
“/” in “Address”, and then press 
the “Enter” key.
When “DHCP Client” is set to “OFF” on the 
projector, IP address is 192.168.150.2. If you 
did not change the IP address in “3. Setting 
up a Network Connection for the 
Projector” (pages 
15
-
16
), enter 
“http://192.168.150.2/”.
3
  A screen for controlling the 
projector appears, ready for 
performing various status 
conditions, control, and settings.
1
2
3