Prepar, ation for

05/9/14
HT-X1(LA)E2.fm
E-18
ENGLISH
TINSZA077SJZZ
HT-X1
7
Prepar
ation for 
Use
 
Speaker connection
To prevent accidental short circuits between   and   terminals,
connect the speaker wires to the speakers first and then to the
subwoofer/amplifier unit.
When connecting speakers, match the colours of the back
label, tube for the speaker wire, and speaker terminal of the
subwoofer/amplifier unit.
Caution:
The supplied speakers are exclusively for the HT-X1. Do not
connect them to other equipment, and do not connect other
speakers to the HT-X1. It may cause malfunction.
Do not mistake the   and  , and right and left terminals of the
speaker wires. (The right speaker is placed on the right when you
face the subwoofer/amplifier unit.) 
Do not stand or sit on the speakers. You may be injured.
Do not allow any objects to fall into or to be placed in the bass
reflex ducts.
 
Attaching the optional floor speaker stand
The front speakers and surround speakers support the optional floor
speaker stand (see page 64). Remove the original stand for each
speaker using a screwdriver first. For details, refer to the manual for
the floor speaker stand.
Note:
Keep the removed speaker stands or screw in a safe place.
Make sure to leave the AC power lead disconnected when con-
necting the speakers.
Subwoofer/
amplifier unit
Example: To connect the left front speaker.
1
  Connect the wires to the speakers.
Red
Red
Black
Black
2
  Connect the other end to the 
  subwoofer/amplifier unit.
Tube (white)
Tube (white)
Speaker 
terminal 
(white)
Label (white)
The speaker grilles are not removable.
Do not short-circuit the speaker wire. If it 
happens with the power on, the protection 
circuit is activated and the system enters the 
stand-by mode. In this case, check that the 
speaker wire is connected correctly before 
turning on the power again.
Incorrect