Troubleshooting chart (continued)
Sudden temperature changes, storage or operation in an extremely
humid environment may cause condensation inside the cabinet
(laser pickup, etc.) or on the transmitter on the remote control.
Condensation can cause the unit to malfunction. If this happens,
leave the power on with no disc in the unit until normal playback is
possible (about 1 hour). Wipe off any condensation on the transmit-
ter with a soft cloth before operating the unit.
If trouble occurs
When this product is subjected to strong external interference
(mechanical shock, excessive static electricity, abnormal supply
voltage due to lightning, etc.) or if it is operated incorrectly, it may
If such a problem occurs, do the following:
Set the unit to the stand-by mode and turn the power on again.
If the unit is not restored in the previous operation, unplug and
plug in the unit, and then turn the power on.
If neither operation above restores the unit, clear all the memory by
Clearing all the memory (reset)
When you reset, all data is deleted and the settings return to the
default. (DVD initial settings are retained.)
The radio makes
Is the unit placed near the TV or computer?
Is the FM aerial or AM loop aerial placed
properly? Move the aerial away from the AC
power lead if it's located nearby.
The preset chan-
nel cannot be re-
Did you remove the plug from the wall sock-
et, or did a power failure occur?
Set the channel again.
The remote con-
trol does not op-
Is the battery polarity correct?
Are the batteries dead?
Is the distance or angle incorrect?
Are there any obstructions in front of the
Is the remote control sensor exposed to
strong light (inverter fluorescent light, direct
Is the remote control for another equipment
The unit cannot
be turned on with
the remote con-
Is the AC power lead of the unit plugged in?
Are the batteries inserted?
Press the ON/STAND-BY button to enter the power stand-by
Whilst pressing down the OPEN/CLOSE button, press the ON/
The unit turns on and the front panel opens. Then it enters the
stand-by mode with the panel open.
Whilst pressing down the button and the FUNCTION button,
press the ON/STAND-BY button until "SYSRESET" appears.