SETTING THE CLOCK

<P=003>
SETTING THE CLOCK 
 POWER 
    ON/            
STAND-BY
CLOCK
MEMORY/SET
TUNING/
TIME
(       )
In this example, the clock is set for the 12-hour (AM 12:00) sys-
tem.
1
Press the ON/STAND-BY button to enter the stand-by mode.
2
Press the CLOCK button.
3
Within 5 seconds, press the MEMORY/SET button.
4
Press the TUNING/TIME (
X
 or 
W
) button to select the time
display mode.
"AM 12:00" 
  The 12-hour display will appear.
                                    (AM  12:00  -  PM  11:59)
"AM 0:00"  
  The 12-hour display will appear.
                                    (AM  0:00  -  PM  11:59)
"0:00"             
  The 24-hour display will appear. 
                                    (0:00  -  23:59)
q
Note that this can only be set when the unit is first installed
or it has been reset (see page 21).
5
Press the MEMORY/SET button.
6
Press the TUNING/TIME (
X
 or 
W
) button to adjust the hour.
q
Press the TUNING/TIME (
X
 or 
W
) button once to advance
the time by 1 hour. Hold it down to advance continuously.
q
When the 12-hour display is selected, "AM" will change auto-
matically to "PM".
7
Press the MEMORY/SET button.
8
Press the TUNING/TIME (
X
  o r  
W
) button to adjust the
minutes.
q
Press the TUNING/TIME (
X
 or 
W
) button once to advance
the time by 1 minute. Hold it down to change the time in 5
minute intervals.
q
The hour setting will not advance even if minutes advance from
"59" to "00".
9
Press the MEMORY/SET button.
q
The clock starts operating from "0" second. 
(Seconds are not displayed.) 
And then the clock display will disappear after a few seconds.
To see the time display:
Press the CLOCK button.
q
The time display will appear for about 5 seconds.
Note:
q
The clock display will flash on and off at the push of the CLOCK
button when the AC power supply is restored after a power
failure occurs or after the AC power cord is disconnected.
If this happens, follow the procedure below to change the clock
time.
To change the clock time:
x
Press the CLOCK button.
y
Within 5 seconds, press the MEMORY/SET button.
z
Perform steps 6 - 9 above.
To change the time display mode:
x
Perform steps 1 - 2 in the section "RESETTING THE
MICROCOMPUTER", on page 21.
y
Perform steps 1 - 9 above.
(Main unit operation)
AM 12:00
AM 0:00
0:00
2
3
4
7
6
5
8
9
CD-PC3500(SEC) TINSE0281AWZZ
12