Be sure to disconnect the power cord from the wall outlet or turn off the circuit breaker
before performing any maintenance.
CLEANING THE FILTER
If the filter is clogged with dust, the amount of air flow will be reduced, resulting in poor
cooling performance. The filter should be cleaned every10 days. At the beginning of
every cooling season or if the air conditioner has not been used for a long period, clean
the filter before starting to operate the unit.
To clean the front panel, grille and cabinet, wipe with a soft, dry cloth or with a cloth
moistened with a mild soap. Rinse carefully by wiping with a damp cloth and dry
Avoid splashing the unit with water. Excessive water will affect electrical insulation and
fire may be resulted during operation.
Never use erosive chemicals or abrasive cleaners on any part of the unit. To avoid
damaging the unit, do not use hot water of over 50°C when cleaning. To clean the
remote control, wipe with a soft dry cloth.
CLEANING OF THE FRONT PANEL, GRILLE, CABINET AND THE REMOTE CONTROL
OILING OF THE COMPRESSOR AND FAN MOTOR IS UNNECESSARY
The compressor is permanently lubricated and is hermetically sealed. The fan motor is lifetime
sealed and does not require oiling.
REMOVE THE FILTER
Open the grille by gently pulling the arrow
marked portion. Then lift and unhook the bot-
tom of the air filter and remove it.
CLEAN THE FILTER
To remove dust from the filter, use a vacuum
cleaner or wash it with clean water.
If the filter is very dirty, wash it with detergent
and rinse carefully with clean water. Dry the
filter with a soft cloth. Do not expose the filter
to heat or dry it under direct sunlight.
RE-INSTALL THE FILTER
Fit the top hooks, and then hook the bottom of
the air filter. Close the grille firmly. Never
operate the unit without installing the filter or
with the grille open. It may result in serious
damage to the unit.
Do not open the grille extremely wide, or provide
stress to the opened grille. The grille may come
off, or the grille shaft may get damaged. If the grille
should come off, replace it by following instructions
given in page 16 "CAUTION".