Panasonic DMC-LS1PP Operating Instruction

Connecting to a PC

Connecting to a PC or Printer

84

VQT0Q58

Connecting to a PC

If you use Windows

®

 98/98SE, install the 

USB driver and then connect it to the 
computer.
(When using Windows Me/2000/XP, Mac 
OS 9.x, Mac OS X, you do not have to 
install the USB driver. Refer to the separate 
operating instructions about PC connection 
for the installation of the USB driver.)

A: USB connection cable (supplied)
B: AC adaptor (DMW-AC1; optional)

1 Turn the camera on and then set 

[USB MODE] on the [SETUP] 
menu to [PC]. (P83)

• If you set [USB MODE] to [PictBridge 

(PTP)] and then connect the camera to 
the PC, messages may appear on the 
screen of the PC.

Select [Cancel] to close the indications 
and disconnect the camera from the 
PC. Connect the camera after you set 
[USB MODE] again.

2 Connect the camera to a PC via 

the USB connection cable 

(supplied).

• Connect the USB connection cable with 

the [

] mark facing the [

1] mark on 

the [DIGITAL] socket.

• Hold the plug 

C to push into or pull out.

D: This message appears during data 

transfer.

[Windows]
The drive appears on the [My Computer] 
folder.
• If it is the first time you are connecting the 

camera to a PC, the required driver is 
installed automatically so that the camera 
can be recognized by the Windows Plug 
and Play, then it appears on the 
[My Computer] folder.

[Macintosh]
The drive is displayed on the screen.
• When you connect the camera with the 

card inserted, the drive is shown on the 
screen as untitled.

• When you connect the camera without the 

card (with the built-in memory used), the 
drive is titled as “LUMIX”.

DIGITAL

V.OUT

DC IN

3V

ACCESS

VQT0Q58ENG.book  84 ページ  2005年2月3日 木曜日 午後7時0分