Please read this manual carefully before using your NEC
LT150Z Projector and keep the manual handy for fu-
Your serial number is located on the bottom of your
LT150Z. Record it here:
To turn off main power, be sure to remove
the plug from power outlet.
The power outlet socket should be installed
as near to the equipment as possible, and
should be easily accessible.
TO PREVENT SHOCK, DO NOT OPEN
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED NEC
This symbol warns the user that uninsulated
voltage within the unit may be sufficient to
cause electrical shock. Therefore, it is dan-
gerous to make any kind of contact with any
part inside of the unit.
This symbol alerts the user that important
information concerning the operation and
maintenance of this unit has been provided.
The information should be read carefully to
TO PREVENT FIRE OR SHOCK, DO NOT EXPOSE
THIS UNIT TO RAIN OR MOISTURE.
DO NOT USE THIS UNIT’S GROUNDED PLUG
WITH AN EXTENSION CORD OR IN AN OUTLET
UNLESS ALL THREE PRONGS CAN BE FULLY
DO NOT OPEN THE CABINET. THERE ARE HIGH-
VOLTAGE COMPONENTS INSIDE. ALL SERVIC-
ING MUST BE DONE BY QUALIFIED NEC SER-
DOC Compliance Notice
This Class B digital apparatus meets all requirements
of the Canadian Interference-Causing Equipment Regu-
3. GSGV Acoustic Noise Information Ordinance:
The sound pressure level is less than 70 dB (A) accord-
ing to ISO 3744 or ISO 7779.
The Federal Communications Commission does not
allow any modifications or changes to the unit EX-
CEPT those specified by NEC Technologies in this
manual. Failure to comply with this government regu-
lation could void your right to operate this equipment.
This equipment has been tested and found to com-
ply with the limits for a Class B digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harm-
ful interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
cause harmful interference to radio or television re-
ception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the fol-
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is con-
• Consult the dealer or an experienced radio / TV
technician for help.
In UK, a BS approved power cable with moulded plug
has a Black (five Amps) fuse installed for use with this
equipment. If a power cable is not supplied with this
equipment please contact your supplier.
IBM is a registered trademark of International Business Machines
Macintosh and PowerBook are registered trademarks of Apple Com-
Other product and company names mentioned in this user's manual
may be the trademarks of their respective holders.
C A U T I O N
This label is on the side of the remote control.