Frigidaire FFRA0511U1, FFRA0511UE User Guide
Using Air Conditioner
To begin operating the air conditioner, follow these steps:
Set the temperature selector to the highest number (Max Cool).
Set the mode control to the hi cool setting.
Adjust the louvers for comfortable air flow (see Air Directional Louvers).
Once the room has cooled, adjust the temperature selector to the setting you
find most comfortable.
Review the “Operating Instructions” section for other settings.
The controls featured in this manual are representative of many available
models. Your model may offer slightly different features.
Rotate the MODE knob to the right to select your choice of fan speeds for air circulation.
Note: When selecting a fan speed, the compressor will not run.
Please always wait 3 minutes when turning unit off then on again, and when changing from cool to fan and back to
cool. This prevents compressor from overheating & possible circuit breaker tripping.
Failure to follow these instructions may be harmful to your unit.
The desired cool setting is selected by rotating the MODE knob to the appropriate location.
“hi cool” has maximum cooling effect and airflow.
“lo cool” has minimum cooling effect and airflow.
This is used to set the desired room temperature when the unit is being operated in
the “COOL MODE”.
To set the desired room temperature, rotate the selector switch to the desired setting.
After the set temperature is achieved, the thermostat will automatically start and stop
the compressor in order to maintain the desired set temperature.
Rotate the temperature selector clockwise for higher cool setting. Higher cool settings
will provide lower room temperature.
Rotate the temperature selector counter-clockwise for lower cool settings. Lower cool
settings will provide higher room temperature.
2009 Electrolux Home Products, Inc.
All rights reserved.
Air Directional Louvers
Air directional louvers control air flow direction. Your air conditioner has the
louver type described below.
Rotate the Auger Wheel until the desired Left/Right direction is obtained.