GAS COOKTOP INSTALLATION INSTRUCTIONS

GAS COOKTOP INSTALLATION INSTRUCTIONS

7

Check alignment of valves after connecting the 
cooktop to the gas supply to be sure the cooktop 
manifold pipe has not been moved.
Disconnect this cooktop and its individual shutoff 
valve from the gas supply piping system during any 
pressure testing of that system at test pressures greater 
than ½ psig (3.5 kPa or 14" (35.6 cm) water column).
Isolate the cooktop from the gas supply piping 
system by closing its individual manual shutoff valve 
during any pressure testing of the gas supply piping 
system at test pressures equal to or less than ½ psig 
(3.5 kPa or 14" (35.6 cm) water column).

7. Connect Electricity to Gas Cooktop

Electrical Requirements

120 volt, 60 Hertz, properly grounded branch circuit 
protected by a 15 amp circuit breaker or time delay fuse. 
Do not use an extension cord with this cooktop.
IMPORTANT Please read carefully.
For personal safety, this appliance must be properly 
grounded.
The power cord of this appliance is equipped with a 
3-prong (grounding) plug which mates with a standard 
3-prong grounding wall receptacle (see Figure 7) to 
minimize the possibility of electric shock hazard from the 
appliance.

The wall receptacle and circuit should be checked by 
a qualified electrician to make sure the receptacle is 
properly grounded.

Where a standard 2-prong wall receptacle is installed, 
it is the personal responsibility and obligation of the 
consumer to have it replaced by a properly grounded 
3-prong wall receptacle.
Do not, under any circumstances, cut or remove the 
third (ground) prong from the power cord.

 

Disconnect electrical supply cord from wall 

receptacle before servicing cooktop.

8. Check Operation

Refer to the Use and Care Guide packaged with the 
cooktop for operating instructions and for care and 
cleaning of your cooktop.

1.  Remove foam caps.

2.  Turn on Electrical Power and Open Main Shutoff 

Gas Valve

3.  Check the Igniters
 

Operation of electric igniters should be checked 
after cooktop and supply line connectors have been 
carefully checked for leaks and the cooktop has been 
connected to electric power. 

 

To operate the surface burner:
A.  Push in and turn a surface burner knob to the 

LITE position. You will hear a small ticking noise; 
this is the sound of the electric ignitor which 
lights the burner.

B.   After the burner lights, turn to the desired flame 

size. The controls do not have to be set at a 
particular mark. Use the marks as a guide and 
adjust the flame as needed. 

Figure 7

Preferred Method

Do not, under any 

circumstances, cut, 

remove, or bypass 

the grounding 

prong.

Power supply cord with 

3-prong grounding plug

Grounding 
type wall 
receptacle