Cutting Paper Manually with the Built in Cutter

1-13
Handling Paper and Other Media
|
1-13
6. Push the paper set lever all the way down, then close the roll paper 
cover. 
PRESS PAUSE BUTTON
 appears on the control panel display.
If you’re using Auto Cut and the edge of the paper is uneven, press 
Cut/Eject
 to recut the edge.
7. Press the 
Pause
 button. The print head moves and the paper feeds into 
printing position automatically. 
READY
 appears on the control panel 
display. (Even if you don’t press 
Pause
, the paper and printer will move 
into printing position automatically after 10 seconds.)
Cutting Paper Manually with the Built-in Cutter
When you’re not using the 
Auto Cut
 setting, you need to cut the paper 
manually after your print job is finished. If you’re printing on canvas, vinyl, 
or other heavy media, you should use scissors or a utility cutter rather than 
the built-in cutter. See page 1-14 for instructions. Follow these steps to cut 
manually with the built-in cutter:
1. If the paper is not positioned correctly, press one of the 
Paper Feed 
buttons to adjust the paper position. Normally, you don’t need to do 
this after a print job is finished.
2. Press the 
Paper Source
 button until the 
Roll Auto Cut 
light comes on. 
3. Press the 
Cut/Eject 
button. The paper is cut.
Caution
To avoid damaging the 
printer, never move the 
paper set lever while the 
Operate or Pause light
is flashing.