Ink Cartridge Safety Instructions

If you use an extension cord with the printer, make sure the total ampere 
rating of the devices plugged into the extension cord does not exceed the 
cord’s ampere rating. Also, make sure the total ampere rating of all 
devices plugged into the wall outlet does not exceed the wall outlet’s 
ampere rating.
Except as specifically explained in the documentation, do not attempt to 
service the printer (or RIP Station 5100) yourself. Opening or removing 
those covers that are marked “Do Not Remove” may expose you to 
dangerous voltage points or other risks. Refer all servicing in those 
compartments to service personnel.
Power down the printer from the control panel, unplug the printer (or 
RIP Station 5100) and refer servicing to qualified service personnel 
under the following conditions: 
If the power cord or plug is damaged; if liquid has entered the printer 
(or RIP Station 5100); if the equipment has been dropped or the case 
damaged; if the printer (or RIP Station 5100) does not operate normally 
or exhibits a distinct change in performance. Adjust only those controls 
that are covered by the operating instructions.
Ink Cartridge Safety Instructions
Do not put your hand inside the printer or touch the cartridges during 
To avoid damaging the printer, do not move the print head by hand.
Under normal circumstances, ink will not come out of the cartridge. If it 
does get on your skin, wash it off with soap and water. If it gets in your 
eyes, flush them immediately with water.
Keep ink cartridges out of the reach of children and do not drink the 
Do not store ink cartridges at high or freezing temperatures. Keep 
cartridges away from direct sunlight.
Do not dismantle the ink cartridges or try to refill them. This could 
result in damage to the print head.
Install the ink cartridge immediately after you remove it from its 
package. Leaving the cartridge unpacked for a long time before use may 
result in reduced print quality.