Packing and shipping
When you transport the machine, use the
packing materials that came with your
machine. Follow the instructions below to
correctly pack your machine. Damage
caused to your machine during transit is not
covered by your warranty.
It is important to allow the machine to
“park” the print head after a print job.
Listen carefully to the machine before
unplugging it to make sure that all
mechanical noise has stopped. Not
allowing the machine to finish this parking
process may lead to print problems and
possible damage to the print head.
Open the ink cartridge cover.
Remove all four ink cartridges. Press
the ink release lever above each
cartridge to release it.
(See Replacing the ink cartridges in
appendix A in the Basic User’s Guide.)
Install the green protective part and then
close the ink cartridge cover.
• Make sure that the plastic tabs on both
sides of the green protective part (1) have
securely clicked into place (2).
• If you are not able to find the green
protective part, DO NOT remove the ink
cartridges before shipping. It is essential
that the machine be shipped with either
the green protective part or the ink
cartridges in position. Shipping without
them will cause damage to your machine
and may void your warranty.
Lift the front of the machine and hook
the long end (1) of the green protective
part into the T-shaped hole underneath
the machine. Push the forked end (2)
onto the top of the paper tray.