Auto adjusting the image

Operation
35
Auto-adjusting the image
In some cases, you may need to optimize the picture 
quality. To do this, press AUTO on the projector or 
remote control. Within 3 seconds, the built-in 
Intelligent Auto Adjustment function will re-adjust 
the values of Frequency and Clock to provide the 
best picture quality. 
The current source information will be displayed in 
the upper left corner of the screen for 3 seconds. 
The screen will be blank while AUTO is functioning.
Fine-tuning the image size and clarity
Searching for details on the projected image
If you need to find the details on the projected image, press D. ZOOM 
+ on the remote control, the center of the image will be magnified. 
When the + button is pressed again, the image is further magnified. Use 
the directional arrows ( , , , ) on the projector or remote 
control to navigate the image. Pressing D. ZOOM - reduces the size of 
the image. When the - button is pressed again, the image is further 
reduced until it is restored to the original size.
The Digital Zoom and Pan functions are also accessible in the DISPLAY 
menu.
Correcting keystone
Keystoning occurs when the projector is not perpendicular to the screen and is where the 
projected image displays visible as a trapezoid shape like either of the following:
Two parallel sides (left and right, or top and bottom) but is noticeably wider on either 
side.
No parallel sides.
To correct the image's shape, you can perform the following steps.
1.
Adjust the projection angle. Move the projector to be in front of the center of the 
screen with the base of the lens level with the top or bottom edge of the screen.
2.
If the image is stilled distorted, or the projector is unable to be positioned as described 
above, you will need to manually correct the image following ONE of these steps.
Press one of the Keystone/Arrow buttons (
/ ,  /
/
,  /
) on 
the projector or remote control to display the Keystone correction page. Press 
1.
Adjust the projected image to the size 
that you need using the zoom ring. 
2.
Then sharpen the image by rotating 
the focus ring.