Remote control effective range, Remote control batteries

Introduction
16
Remote control effective range
Infra-Red (IR) remote control sensors are located on the front and the back of the projector. 
The remote control must be held at an angle within 30 degrees perpendicular to the 
projector's IR remote control sensors to function correctly. The distance between the remote 
control and the sensors should not exceed 6 meters (~ 20 feet).
Make sure that there are no obstacles between the remote control and the IR sensors on the 
projector that might obstruct the infra-red beam. 
Remote control batteries
1.
To open the battery cover, turn the remote control over to view its back, push on the 
finger grip on the cover and slide it up in the direction of the arrow as illustrated. The 
cover will slide off.
2.
Remove any existing batteries (if necessary) and install two AAA batteries observing 
the battery polarities as indicated in the base of the battery compartment. Positive (+) 
goes to positive and negative (-) goes to negative.
3.
Refit the cover by aligning it with the base and sliding it back down into position. Stop 
when it clicks into place.
Avoid leaving the remote control and batteries in an excessive heat or humid environment 
like the kitchen, bathroom, sauna, sunroom or in a closed car. 
Replace only with the same or equivalent type recommended by the battery manufacturer.
Dispose of the used batteries according to the manufacturer's instructions and local 
environment regulations for your region.
Never throw the batteries into a fire. There may be danger of an explosion. 
If the batteries are dead or if you will not be using the remote control for an extended 
period of time, remove the batteries to avoid damage to the remote control from possible 
battery leakage.
Operating the projector from the 
front
App
rox.
 15°
App
rox.
 15°
Operating the projector from the 
rear
1
2
3