Notices

v
Notices
Federal Communications Commission Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions:
•  This device may not cause harmful interference, and
•  This device must accept any interference received including interference that 
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are 
designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses and can radiate radio 
frequency energy and, if not installed and used in accordance with manufacturer’s 
instructions, may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular installation. If 
this equipment does cause harmful interference to radio or television reception, 
which can be determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more of the following 
measures:
•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment to an outlet on a circuit different from that to which the 
receiver is connected.
•  Consult the dealer or an experienced radio/TV technician for help.
Canadian Department of Communications Statement
This digital apparatus does not exceed the Class B limits for radio noise emissions 
from digital apparatus set out in the Radio Interference Regulations of the 
Canadian Department of Communications.
This class B digital apparatus complies with Canadian ICES-003.
Macrovision Corporation Product Notice
This product incorporates copyright protection technology that is protected by 
U.S. patents and other intellectual property rights. Use of this copyright protection 
technology must be authorized by Macrovision, and is intended for home and other 
limited viewing uses only unless otherwise authorized by Macrovision. Reverse 
engineering or disassembly is prohibited.
WARNING!  The use of shielded cables for connection of the monitor to the 
graphics card is required to assure compliance with FCC regulations. Changes 
or modifications to this unit not expressly approved by the party responsible for 
compliance could void the user’s authority to operate this equipment.